HMT Tungsten Carbide MultiSink ULTRA Coated 55mm, 90°
code
601056-0550
£493.39
£411.16
Call For Details - 01772 230021
Ultra coated Multisink for increased wear resistance whilst countersinking the toughest materials like Hardox, Inconel and Armor plate.The MultiSink™ is a worldwide unique new Combination Countersink Tool designed & developed by HMT for use with Magnetic Drills. The multisink combines with the VersaDrive® product range to allow you to Broach & Countersink, Drill & Countersink, Tap & Countersink or even Drill, Tap & Countersink in one operation.
Features & Benefits
Innovative combination countersinking tool Save time completing countersunk holes Suitable for holes 16mm and above Pilot feature gives a precise, concentric fit for excellent performance
Features & Benefits
Innovative combination countersinking tool
Write Your Own Review
109mm Length
19.05mm (3/4") Weldon Shank
90 Degree point angle
Countersink starting diameter = 14mm
The extreme hardness and resistance of wear plate makes machining it extremely challenging.
Good results are dependent on the right setup - including high torque/slow speed, geared Magnet Drills, such as the VersaDrive® V125T, and correct lubrication
For predrilled holes the MultiSink should always be used with a pilot to avoid damage
When used for multiple operations eg Drilling then Countersinking, the correct RPM should be used for each separate operation
Constant coolant application is advisable to carry away any heat generated by cutting, as heat build up can cause work hardening
Do not allow the countersink to vibrate over swarf while cutting as this will cause chatter, ultimately causing the cutting edge to chip & blunt
19.05mm (3/4") Weldon Shank
90 Degree point angle
Countersink starting diameter = 14mm
The extreme hardness and resistance of wear plate makes machining it extremely challenging.
Good results are dependent on the right setup - including high torque/slow speed, geared Magnet Drills, such as the VersaDrive® V125T, and correct lubrication
For predrilled holes the MultiSink should always be used with a pilot to avoid damage
When used for multiple operations eg Drilling then Countersinking, the correct RPM should be used for each separate operation
Constant coolant application is advisable to carry away any heat generated by cutting, as heat build up can cause work hardening
Do not allow the countersink to vibrate over swarf while cutting as this will cause chatter, ultimately causing the cutting edge to chip & blunt
Login and Registration Form